Appliance installation in Fairborn runs $150 for a basic dishwasher swap up to $1,800 for a built-in refrigerator and $1,100 for a vented range hood that needs a new exterior cap. Most jobs finish same-day, 1 to 4 hours. We handle 240V electrical and plumbed gas hookups where the county requires it, and we coordinate the Greene County inspection when one's needed.
The Fairborn-specific issue on appliance installs: gas service. Natural gas reaches most of the US-444 corridor but is spotty east of State Route 316 and in the Broad Street corridor pocket, so if you want a gas range you're often on propane. Converting an LP range to a specific propane regulator and jet set has to happen before the first use, not after, or you'll void the warranty. We stock the Thermador, Wolf, and Viking LP conversion kits and do them on the install. For houses on city gas (most of downtown Fairborn and the US Highway 29 corridor), we pull the gas-fitting permit through Greene County, $50 to $85, and hook you up with CSST or black-iron pipe per code.
Range hoods are where a lot of Fairborn installs go sideways. If you're installing a true vented hood (not a recirculating one), it needs an exterior roof or wall cap with a backdraft damper, and the duct run needs to be under 25 feet with no more than two 90-degree elbows. In single-story ranch homes with a flat or low-slope roof, we almost always have to cut a new cap on the roof or the side wall. That adds $450 to $900 to the install. Skipping the exterior cap and running the duct into the attic is a code violation (will fail a home inspection on resale) and dumps grease into your attic insulation.
Built-in refrigerators (Sub-Zero, Thermador Freedom, Viking) are the install that costs more than people expect. $1,400 to $1,800 is realistic, and that's assuming the cabinet cutout is already correct. Panel-ready models need door panels that match your cabinets, which have to be custom-fit at install. We measure twice before the delivery driver walks in, because a $12,000 Sub-Zero that doesn't fit the opening is a very expensive return.
What we handle
Dishwasher Installation
Standard or ADA-height dishwasher, cabinet brackets, water line with braided stainless, drain hose, air-gap or high-loop per code.
Slide-In Range Installation
30 or 36-inch slide-in, anti-tip bracket per code, 240V plug or gas line hookup, LP conversion if propane.
Cooktop Install (Gas or Induction)
Drop-in cooktop with cabinet cutout trim, 240V or gas line hookup, LP conversion if needed.
Built-In Wall Oven Install
Single or double wall oven, 240V hookup, cabinet bracket, trim kit fit. Weight support check on older cabinetry.
Range Hood Install with Exterior Vent
True-vented hood with duct run, exterior roof or wall cap, backdraft damper, mesh screen for Ohio insect protection.
Emergency Appliance Replacement
Same-week swap after a dead dishwasher, fridge, or range. Haul-away of old unit, hookup and function test.
Built-In Refrigerator Install
Sub-Zero, Thermador Freedom, Viking Pro. Cabinet-cutout verification, panel fit, hinge adjustment.
Commercial Appliance Install
Small-restaurant and short-term rental appliance installs along the US-444 corridor. Higher-amp hookups and vented commercial hoods.
How the job goes
1. Pre-Install Measure (free, same-week visit)
Confirm the appliance fits the opening, check 240V or gas service, note any cabinet or wall modifications needed before delivery.
2. Delivery Coordination
We can meet the delivery truck and inspect for crate damage before signing. Saves a return trip if something's damaged in transit.
3. Install (1 to 4 hours typical)
Shut off water/gas/power, remove old appliance, set new appliance, connect utilities, test. Full function test before we leave.
4. Code Permit and Inspection (when required)
For gas and 240V electrical, we pull the permit with Greene County and coordinate the inspection. Usually within 5 business days.
What's included
- Free pre-install measure and utility check
- Removal and haul-away of old appliance (same room)
- Anti-tip bracket on freestanding ranges (code required)
- New water line (braided stainless) for dishwasher and ice maker
- New gas-flex connector where applicable
- LP conversion kit on propane installs
- Exterior vent cap with backdraft damper (vented hoods)
- Greene County permit and inspection coordination
- Full function test before we leave
- 1-year written workmanship warranty
What it costs
Fairborn appliance installs typically $150 to $1,800. Dishwasher $150 to $280. Range $220 to $480. Vented range hood $550 to $1,100. Built-in refrigerator $1,400 to $1,800.
| Job | Typical price | Notes |
|---|---|---|
| Dishwasher Install (swap) | $150-$280 | Standard swap, existing water and drain in place. Add $50 for an air-gap install. |
| Slide-In Range Install (electric) | $220-$380 | 240V outlet already in place. Anti-tip bracket included. |
| Slide-In Range Install (gas) | $320-$480 | Gas line already in place. LP conversion included if propane. Permit fee extra if required. |
| Built-In Wall Oven | $280-$520 | Single or double. Cabinet bracket and trim kit install. 240V hookup included. |
| Vented Range Hood with Exterior Cap | $550-$1,100 | Duct run under 25 ft. New roof or wall cap included. Backdraft damper and insect screen. |
| Built-In Refrigerator Install | $1,400-$1,800 | Sub-Zero, Thermador, Viking. Panel fit, hinge tune, water line. Cabinet opening must already be correct. |
Ranges are typical for Appliance Installation jobs in Fairborn and confirmed with an exact written quote before any work starts.